Mallinckrodt NPB-190 Manuale dell'Operatore Scaricare il pdf (Pagina 42)

Start-Up and Use

LIMITS

WARNING: Each time the monitor is used, check alarm

limits to ensure that they are appropriate for the patient

being monitored.

Overview

When the NPB-295 is first turned on, alarm limits are set to their

power-on default values. Power-on default alarm limits can be

changed by qualified service personnel, using the instructions

described in the NPB-295 service manual.

You can temporarily change alarm limits from their power-on

default values if necessary, as described below. Changes you

make will remain in effect until you change them again, or until

you turn off the NPB-295.

Viewing Current Alarm Limits

To view the current alarm limit values from the main menu, press

the LIMITS softkey. The current upper and lower alarm limits

for %SpO

2 and pulse rate are displayed.

Changing Alarm Limits

Use the SELECT softkey to select the parameter whose value you

want to change. Use the Adjust Up/Down Buttons to change the

settings. The setting takes effect immediately and remains in

effect when the alarm setting menu is exited.

Alarm Limits Changed Indicator

If alarm limits are changed from the NPB-295’s power-on

defaults, a decimal point appears after the displayed value and in

the %SpO

2 and Pulse Rate Display as illustrated in Figure-9. The

decimal point remains on the display until the NPB-295 is turned

off or the limit is returned to its default value.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 86 87

Nessun commento

Mallinckrodt NPB-190 Manuale dell'Operatore Pagina 42